Steps to change MTU settings in windows operating system

MTU ( Maximum transmission unit ) is a size of largest protocol data unit that the layer can pass onward . In standard connection we can fix this size of MTU . A larger MTU is high efficient because it comprises of largest data units in each packet heads .  Today i wold like to share a article about how to change your MTU ( Maximum transmission unit ) size of your internet connection using command prompt . Let us look how this done .

Follow this steps :

• Open your command prompt ( CMD ) you can type cmd from start ( In windows )

• Type the following command in command prompt 

netsh int ip show int 

• You can see lot of MTU size across the connection name . You can change the size of MTU from using commands .

• Type the following command to change the size of MTU . Here i change Wi-Fi value .

netsh interface ipv4 set subinterface "Wi-FI" mtu=1458 store=persistent

• Again type the below command to check the size of MTU .  

netsh int ip show int  

• That's it . You done .